| |
1.5 Units and Accessories Supplied
The following two tables may be used to: 1) check the contents or your order
and, 2) to order additional Units or components.
| Unit Part Number |
Unit and Description
|
Subassy Part Number |
| 03606-0300 C |
AT
150 Transponder Assy, 14V |
|
|
Complete with: |
|
|
AT 150 Transponder, 14V |
01258-0101 |
|
Tray Assy |
56282-0102 |
|
Antenna Assy |
71233-0101 |
|
Installation Kit |
03604-0500 |
| 03606-0302 C |
AT
150 Transponder Assy, 14V (German Version) |
|
|
Complete with: |
|
|
AT 150 Transponder, 14V |
01258-0101 |
|
Tray Assy |
56282-0102 |
|
Antenna Assy |
71233-0101 |
|
Antenna Cable Assy (with BNCs), 96 inches long (243 cm) |
90624-0096 |
|
Installation Kit |
03604-0500 |
TABLE 1.2. INSTALLATION KIT (03604-0500) N Item Part Number Description Qty 1
81238-0034 SPACER 2 2 41316-0009 CONNECTOR, 18 pin (Molex) 1 3 41317-0001
CONTACT, Crimp type 24 4 82802-0005 WASHER, Lock. Int. Tooth. #6 4 5 82900-0008
NUT, Hex, 6-32 4 6 81324-0004 WASHER, Lock, Split, #4 2 7 82814-0004 SCREW. Bind
Hd, 4-40 x 5/16 2 8 82815-0005 SCREW, Bind Hd, 6-32 x 3/8 4 9 41152-0005
CONNECTOR, BNC 2 10 99090-0001 PAD, Spacer 4
1.6 Optional Accessories
- Altitude Reporter -A R-500, order number 03725-0300. (Where required use
MP 10 Voltage Converter - 28 to 14 Vdc).
- Altitude Digitizer Kit, order number 03604-0502.
- Voltage Converter - required only for 28 volt installations: Narco Voltage
Converter(s) MP 10 Voltage Converter, P/N 03710-0500 - see
details elsewhere in this manual OR MP 15 Voltage Converter (Dual) P/N
03223-0302 (TSO'd to DO-160 -A2C2/ A/JY /XXXXXXZBBBA) This TSO'd Dual
Converter consists of two 28 Vdc to 14 Vdc Voltage Converters, each capable
of 2.0 Amperes, on a single heat sink. Intended for use in 28V aircraft, the
MP-15 will supply 14V to two navigation units (NAV's, ADF's, Transponders,
etc.). Do not use with AR-500.
- Low-Loss Antenna Cable - 8 foot, order number 90624-0096.
- Low-Loss Antenna Cable - 9 foot, order number 90624-0108.
- Dealer Starter Kit, order number 03604-0501.
- Passive Voltage Converter Kit - 03604-0504.
1. 7 Miscellaneous Items Required But Not Supplied
Refer to Installation Section for additional
details.
- Sufficient length of #22 and #16 AWG hookup wire.
- Molex Hand Crimper, HT-1921, Narco Part Number 41314-0001.
- Molex Pin Ejector, HT-1884, Narco Part Number 41314-0002.
1.8 Operator License Requirements
The Federal Communications Commission requires that the transmitter in this
equipment hold a Restricted Radio Telephone Operator Permit, or a license of a
higher class. A permit may be obtained by any U.S. Citizen from the nearest
field office of the FCC; no examination is required.
|
|